As a guest user you are not logged in or recognized by your IP address. You have
access to the Front Matter, Abstracts, Author Index, Subject Index and the full
text of Open Access publications.
This paper deals with the results received by carried out tensile tests of the structural glass plates supplied with three different types of stress raisors. The first type of specimens is the plate with a circular hole located in the centre of the plate, the second one is the plate with a slot hole located in the centre of the plate, and the third one is the plate with the semicircular notches located at the opposite edges. The results of test of these specimens were compared both among themselves and both with the results of the specimens without stress raisors. The specimens were made from tempered glass of 6 mm thick with the arrising edges. All tests were carried out under equal conditions; the load level has been raised within each 1.0 kN. The experiment was performed with an optical device for measurement of the stresses by birefringence. Detailed analysis of the obtained results is given in this paper.
This website uses cookies
We use cookies to provide you with the best possible experience. They also allow us to analyze user behavior in order to constantly improve the website for you. Info about the privacy policy of IOS Press.
This website uses cookies
We use cookies to provide you with the best possible experience. They also allow us to analyze user behavior in order to constantly improve the website for you. Info about the privacy policy of IOS Press.